Warm air at the vents, a tripped breaker, or ice building up on the coil isn't something to sit on in Hot Springs, SD heat. We check refrigerant charge, compressor amp draw, and coil condition before a single part gets recommended.
Freon top-offs without finding the actual leak are one of the most common ways homeowners get overcharged for Ac Repair. We pull static and running pressures, check superheat and subcooling against manufacturer spec, and use electronic leak detection to find the real fault — a slow leak repaired properly outlasts three top-offs.
Non-negotiables on every cooling call.
Every tech handling refrigerant holds current EPA 608 certification, which is a legal requirement we take seriously, not a formality.
We prioritize no-cool calls, and most Hot Springs requests get a same-day slot even in the busiest stretch of summer.
You approve a fixed price before repairs begin, whether it's a capacitor or a compressor.
Our trucks carry electronic leak detectors and UV dye so the leak gets found, not just temporarily papered over.
Six repairs that cover the vast majority of cooling failures we see.
We locate the leak with electronic sensors or UV dye, repair the line or fitting, then recharge to factory spec and verify with pressure readings — not just refilled and sent on its way.
A compressor that hums without starting, or pulls high amps, gets tested at the windings and start capacitor before we ever recommend replacement.
Ice on the coil is a symptom, not the problem — we trace it back to airflow restriction or low charge and fix what's actually causing it.
Dual-run capacitor failure is a leading cause of a condenser that won't kick on, and it's a same-visit fix once confirmed with a microfarad reading.
Debris-caked condenser coils can't shed heat efficiently, which spikes head pressure and stresses the compressor — we clean and inspect fins during the visit.
A blown low-voltage fuse or a tripped disconnect can mimic total system failure — ruling these out first can save a needless compressor replacement.
What to expect once you dial in.
Describe the symptom — warm air, ice on the lines, breaker tripping — and we schedule the nearest tech.
A fully stocked truck arrives within your confirmed window, ready to diagnose on the spot.
Pressure readings and amp draws get measured before any refrigerant is added — then you get a flat-rate quote to approve.
Same-visit completion in most cases, covered under warranty once you sign off.
Reviews from completed cooling repairs.
AC was blowing warm during a heat wave and they had someone out same day. Found a refrigerant leak at the schrader valve, fixed it right, cold air within the hour.
— K. Munoz, homeowner
Previous company just added freon twice and charged me both times. This tech actually found the leak with dye and fixed the fitting.
— D. Harmon, homeowner
Compressor was humming and not starting. Ended up being the capacitor, fifteen-minute fix once diagnosed, fair flat price.
— P. Nakamura, small business owner
Coil was frozen solid, tech explained it was an airflow issue from a dirty filter combined with low charge, fixed both.
— S. Ferraro, homeowner
What people ask before we dispatch.
The most common causes are a refrigerant leak, compressor failure, or a coil too dirty to reject heat, and we check all three.
We can, but we'll always tell you it's temporary — refrigerant doesn't get used up, it leaks out somewhere.
Cooling failures get priority routing, and most same-day requests are seen within a few hours.
It won't hurt anyone, but continuing to run the unit while iced up risks compressor damage, so it's worth addressing quickly.
Our Ac Repair focus is central split-systems and packaged units, though we can advise on window units too, and can point you in the right direction for window units.
A complete pressure and electrical workup plus a written explanation, applied to the repair cost if you proceed.
Our AC repair coverage spans Hot Springs and the nearby zips shown here — call to confirm a same-day slot.
Call +1-844-611-2875
